Heat Pump Installation and Replacement in Fresno, CA
A new heat pump in Fresno typically costs about $5,700 to $9,100 installed for common 2 to 4 ton systems, depending on efficiency, ducts and whether your electrical panel needs work. Fresno cools far more than it heats, which makes a heat pump a practical way to replace both an old air conditioner and an old furnace.
We size it for your home, handle the permit, and tell you honestly what rebates are available right now. Emergency service is available 24/7.
Quick answer: what does a heat pump cost in Fresno?
Average installed prices in Fresno from our pricing guide are about $5,700 for a 2 ton system, $7,400 for a 3 ton and $9,100 for a 4 ton. Higher efficiency models cost more, and an electrical panel upgrade or duct work adds to the total.
See the heat pump installation pricing guide.
| System size | Typical home size | Fresno average installed |
|---|---|---|
| 2 ton | Under 1,400 sq ft | $5,700 |
| 3 ton | 1,800 to 2,200 sq ft | $7,400 |
| 4 ton | 2,600 to 3,200 sq ft | $9,100 |
Examples of our work
Why a heat pump fits Fresno
Fresno's heating season is short and mild, with winter lows that rarely stay far below freezing, while the cooling season runs from May into October. A heat pump is an air conditioner that can run in reverse to heat, so one system handles both.
In Fresno's winter, outdoor air is still warm enough for a heat pump to heat efficiently.
That makes replacing a failing furnace and an aging AC with one heat pump an easy case to price. If your gas furnace is newer and works well, keeping it and replacing only the AC can make more sense, and we will tell you if that is the better path.
On the rules: the Bay Area's zero NOx furnace rule does not cover Fresno. The California Air Resources Board has proposed a statewide zero emission standard for new space and water heating equipment, but as of mid 2026 it had not been adopted.
Today the choice between a furnace and a heat pump is yours.
Rebates and incentives: what is available today
Where things stand: HEEHRA, which paid up to $8,000 to lower income households when it was open, stopped taking new single family reservations on February 24, 2026. The federal credit ended after 2025.
We will not promise a rebate that is not approved. The rebates and rules guide explains what is open and what to ask any contractor.
Utility programs from PG&E may still apply, and we will tell you what we know applies to your address. Remember that California programs need approval before work starts.
Is a heat pump right for your home?
Strong candidates:
- Your furnace is old and your AC is also near the end of its life.
- You have electric resistance heat, where a heat pump is a big efficiency upgrade.
- You are adding or converting space, like a garage or backyard unit.
- You have solar panels, which pair well with a heat pump.
Weaker candidates: a newer gas furnace in good shape, a home with very poor insulation (fix that first), or an electrical panel that cannot take the load without an expensive upgrade. We check these during the estimate so you know before you decide.
What a good heat pump installation includes
Heat pumps are more sensitive to installation quality than a plain AC. A sloppy install gives you weak heating in winter, poor cooling in summer and higher bills all year. A proper job includes:
- A load calculation that sizes the system to your home, not to the old unit.
- Equipment selected to match that load.
- An evaluation of the ducts, since heat pumps often need different airflow from an AC only system.
- Refrigerant charge verified, not guessed.
- Defrost operation and auxiliary heat tested.
- The permit and California energy code steps, which can include duct testing and sealing.
How a heat pump installation works
- We look at your home. Existing equipment, ducts, electrical panel, and where the indoor and outdoor units will go.
- We size and select. Capacity from the home's needs, and the efficiency options explained.
- You get options and prices. Including any panel or duct work, before work begins.
- We pull the permit and install. We set the equipment, run the lines and electrical, and remove the old equipment.
- We test it in both modes. Airflow, refrigerant charge, defrost, and heating and cooling performance.
- We walk you through it. How the thermostat works in each mode, what defrost looks like, and how to maintain it.
Efficiency ratings and cost
Heat pump efficiency is rated in SEER2 for cooling and HSPF2 for heating. Typical price steps from our guide:
| Rating | Tier | Added to base price |
|---|---|---|
| 14.3 to 15 SEER2 and 7.5 HSPF2 | Federal minimum | Base price |
| 16 to 17 SEER2 and 8 to 8.5 HSPF2 | Mid efficiency | Add $600 to $1,400 |
| 18 to 20 SEER2 and 9 HSPF2 | High efficiency | Add $1,500 to $2,800 |
| 21 SEER2 or more and 9.5 HSPF2 or more | Premium inverter | Add $3,000 to $6,000 |
Because a Fresno heat pump cools for so many hours, a higher SEER2 rating tends to pay back faster here than in a mild climate.
New residential systems use lower global warming potential refrigerants such as R-454B or R-32 under the EPA's Technology Transitions rule.
Ask which refrigerant your system uses.
Choosing a heat pump that holds up on a 105 degree day
A heat pump's cooling capacity drops as the outdoor temperature climbs, and Fresno asks for the most capacity on exactly the days when the equipment is working hardest. When you compare quotes, ask what capacity the system delivers at high outdoor temperatures, not only its rating at the standard test condition.
A system that looks right on paper can fall short on a 108 degree afternoon.
Variable speed (inverter) heat pumps tend to hold their capacity better and run more quietly, and they also tend to cost more. Two speed models sit in the middle.
We explain the trade off with your home's size and sun exposure in mind and give you the numbers side by side.
Placement matters in the Valley too. An outdoor unit on a west wall in full afternoon sun runs hotter than one in shade, and a unit boxed in by a fence or shrubs cannot shed heat.
We pick a spot with good airflow and, where we can, afternoon shade, without blocking service access.
Ductless heat pumps for additions and garages
If a room, addition, garage conversion or backyard unit has no ducts, a ductless mini split is a heat pump that heats and cools without ductwork. We size it for the space and place the indoor unit so the air reaches where you sit and sleep.
Where we install heat pumps in Fresno and Clovis
We serve Fresno and Clovis, including the Tower District, Old Fig Garden, Fig Garden, Van Ness Extension, Woodward Park, Copper River, Sunnyside and Bullard areas.
See heat pump repair in Fresno, furnace replacement in Fresno and HVAC in Fresno.
Brands we service
We repair and install all major brands. Each brand page lists the models we install, the problems we see most and what the warranty typically covers. See how we match a technician to your brand.
Fresno, CA on the map
Common questions
How much does a heat pump cost in Fresno?
Average installed prices in our guide are about $5,700 for a 2 ton, $7,400 for a 3 ton and $9,100 for a 4 ton. Efficiency, ducts and electrical work change the total.
Is the $8,000 California heat pump rebate available?
As of February 24, 2026, single family HEEHRA rebates were fully reserved statewide and not accepting new reservations, per TECH Clean California. Check the program page for current status.
Is there a federal tax credit for heat pumps in 2026?
No. The federal Section 25C credit ended for equipment placed in service after December 31, 2025.
Will a heat pump heat my Fresno home in winter?
Yes. Fresno's winters are mild enough for heat pumps to work efficiently. Some systems add electric backup heat for the coldest mornings.
Do I need a new electrical panel?
Sometimes. It depends on your panel's capacity and what else it powers. We check during the estimate.
Can I use my existing ducts?
Often yes, if they are in good condition and sized for the airflow. We test and tell you if repairs or sealing would help.
Is a heat pump cheaper to run than a gas furnace?
It depends on your electricity and gas rates and how you use the system. We can compare estimated costs for your home using current rates.
Do I need a permit?
Yes, in most cases. We handle it.
Talk to a person
Call any hour for emergency service, or reach us during business hours for a visit or a quote.